Analog-style octave divider (-1 octave). Produces a sub-octave signal by multiplying the input waveform by a smoothed flip-flop that toggles at zero crossings.
The octave divider detects zero crossings in the input signal and uses a flip-flop to invert the polarity of every other half-cycle. This effectively halves the fundamental frequency while preserving the original waveform shape and timbre — the same principle used in classic analog octave divider pedals (Boss OC-2, EHX Octave Multiplexer).
Bypasses the module processing when activated (ON).
Audio input flow(s).
Audio output flow(s).
Dry/wet blend. At 0 the output is the unprocessed input signal; at 1 the output is fully the sub-octave signal.
Low-pass filter cutoff for the sub-octave signal. Range: 0..1, mapping to 100..5000 Hz. Lower values produce a darker, rounder sub tone; higher values let more harmonics through.
Button. Opens the manual page of the selected object (or of its parent module for a control) in the web browser. If no page exists for this object, an error is traced in the trace panel.
For more details about information/help creation, see create-help-file.
Free multi-line text attached to the module, saved with the patch. It is only meant as an internal note for the patch designer: it is not displayed in the interface.
visible only in god mode, see setup-panel-tab-expert.
Read-only, not saved. Current private numeric ID of the object, used internally to identify it (for example as the target of a bind ID).
Read-only, not saved. Private ID used to store and recall the values of this control in presets.
Button. Generates a new unique ID, original ID and preset ID for the object. Use it if you experience difficulties in Polyphonic mode or if two objects share the same ID. Preset values and binds referring to the old IDs are lost.
Read-only, not saved. Absolute address of the object in the Usine objects tree, built from the workspace root. This is the address to use to reach the object from scripts, the objects panel or remote messages. Only shown for objects that are registered in the objects list. See objects-address.
Read-only, not saved. Address of the object relative to the current patch, valid inside that patch only. See objects-address.
Free user-defined address for the object (empty by default). When set, the object is also registered in the objects tree under this name, so it can be reached independently of its position in the workspace (the value is also reported in the mouse-over and mouse-down chunks). Changing it rebuilds the objects list. Only available on objects that support a user address. See objects-address.
version 7.0.250121
Edit All Pages