Provides access to settings and commands of the main grid-panel.
See grid-panel
for more info.
Turns the main grid ON or OFF.
Restarts the grid from the beginning.
Replays the current section from the beginning.
Goes to the previous section.
Goes to the next section.
Goes to the last section of the grid.
Continues to the next section without stopping or looping.
Suspends the grid at the current section position.
Elapsed time since the beginning of the section.
Remaining time until the end of the section.
List of sections available in the grid.
Section speed factor.
Comma separated text to set captions of each section.
Number of lines displayed in the grid.
Height of the info line at the bottom of the grid.
When ON, the section number is displayed in front of the section caption.
When ON, loads the next playlist file at the end of the grid.
Name of the next play list workspace file to load.
When ON, fades are applied when going backward in the grid.
Sets the current section number.
Button. Opens the manual page of the selected object (or of its parent module for a control) in the web browser. If no page exists for this object, an error is traced in the trace panel.
For more details about information/help creation, see create-help-file.
Free multi-line text attached to the module, saved with the patch. It is only meant as an internal note for the patch designer: it is not displayed in the interface.
visible only in god mode, see setup-panel-tab-expert.
Read-only, not saved. Current private numeric ID of the object, used internally to identify it (for example as the target of a bind ID).
Read-only, not saved. Private ID used to store and recall the values of this control in presets.
Button. Generates a new unique ID, original ID and preset ID for the object. Use it if you experience difficulties in Polyphonic mode or if two objects share the same ID. Preset values and binds referring to the old IDs are lost.
Read-only, not saved. Absolute address of the object in the Usine objects tree, built from the workspace root. This is the address to use to reach the object from scripts, the objects panel or remote messages. Only shown for objects that are registered in the objects list. See objects-address.
Read-only, not saved. Address of the object relative to the current patch, valid inside that patch only. See objects-address.
Free user-defined address for the object (empty by default). When set, the object is also registered in the objects tree under this name, so it can be reached independently of its position in the workspace (the value is also reported in the mouse-over and mouse-down chunks). Changing it rebuilds the objects list. Only available on objects that support a user address. See objects-address.
version 7.0.250121
Edit All Pages