Detects the slope direction of a data signal. Outputs separate gates for rising, falling, and steady states, plus triggers on peaks (local maxima) and troughs (local minima). Use it for envelope following, gesture analysis, direction detection, or firing events at turning points.
Bypasses the module processing when activated (ON).
Input Data flow(s).
ON (1) when the input signal is increasing.
ON (1) when the input signal is decreasing.
ON (1) when the input signal is stable (change is within the threshold).
Fires a trigger when a local maximum is detected (signal transitions from rising to falling or steady).
Fires a trigger when a local minimum is detected (signal transitions from falling to rising or steady).
Minimum change per processing block required to count as rising or falling. Changes smaller than this value are considered steady. Increase this to ignore small fluctuations.
Button. Opens the manual page of the selected object (or of its parent module for a control) in the web browser. If no page exists for this object, an error is traced in the trace panel.
For more details about information/help creation, see create-help-file.
Free multi-line text attached to the module, saved with the patch. It is only meant as an internal note for the patch designer: it is not displayed in the interface.
visible only in god mode, see setup-panel-tab-expert.
Read-only, not saved. Current private numeric ID of the object, used internally to identify it (for example as the target of a bind ID).
Read-only, not saved. Private ID used to store and recall the values of this control in presets.
Button. Generates a new unique ID, original ID and preset ID for the object. Use it if you experience difficulties in Polyphonic mode or if two objects share the same ID. Preset values and binds referring to the old IDs are lost.
Read-only, not saved. Absolute address of the object in the Usine objects tree, built from the workspace root. This is the address to use to reach the object from scripts, the objects panel or remote messages. Only shown for objects that are registered in the objects list. See objects-address.
Read-only, not saved. Address of the object relative to the current patch, valid inside that patch only. See objects-address.
Free user-defined address for the object (empty by default). When set, the object is also registered in the objects tree under this name, so it can be reached independently of its position in the workspace (the value is also reported in the mouse-over and mouse-down chunks). Changing it rebuilds the objects list. Only available on objects that support a user address. See objects-address.
version 7.0.250121
Edit All Pages