Multi channels zero latency convolution module to be used as a convolution reverb.
Audio input flow(s).
Audio output flow(s).
Enables or disables the reverb calculation.
Amount of the original signal and processed signal.
Frequency of the low-cut filter applied to the input before the convolution.
for 20hz frequency, no low-cut filter is applied.
Pre-delay applied to the input before the calculation of the reverb.
Name of the Impulse Response audio file.
Size factor of the impulse response, used to reduce the reverberation time. For 1 value, the full impulse is used, for 0.5 half of the impulse, etc.
Gives the impulse duration in millisecond calculated as impulse size x original impulse duration.
When ON, the impulse is normalized. So all impulses have an equivalent power.
Button. Opens the manual page of the selected object (or of its parent module for a control) in the web browser. If no page exists for this object, an error is traced in the trace panel.
For more details about information/help creation, see create-help-file.
Free multi-line text attached to the module, saved with the patch. It is only meant as an internal note for the patch designer: it is not displayed in the interface.
visible only in god mode, see setup-panel-tab-expert.
Read-only, not saved. Current private numeric ID of the object, used internally to identify it (for example as the target of a bind ID).
Read-only, not saved. Private ID used to store and recall the values of this control in presets.
Button. Generates a new unique ID, original ID and preset ID for the object. Use it if you experience difficulties in Polyphonic mode or if two objects share the same ID. Preset values and binds referring to the old IDs are lost.
Read-only, not saved. Absolute address of the object in the Usine objects tree, built from the workspace root. This is the address to use to reach the object from scripts, the objects panel or remote messages. Only shown for objects that are registered in the objects list. See objects-address.
Read-only, not saved. Address of the object relative to the current patch, valid inside that patch only. See objects-address.
Free user-defined address for the object (empty by default). When set, the object is also registered in the objects tree under this name, so it can be reached independently of its position in the workspace (the value is also reported in the mouse-over and mouse-down chunks). Changing it rebuilds the objects list. Only available on objects that support a user address. See objects-address.
version 7.0.250121
Edit All Pages