Monophonic audio-to-MIDI converter. Analyzes an audio input using the McLeod Pitch Method (MPM) with onset detection and a pitch stability state machine, then outputs corresponding MIDI note-on messages with velocity and optional pitch bend for micro-tuning.
Best suited for monophonic sources (voice, solo instrument). Detects one pitch at a time.
Activates or deactivates the module.
Audio input flow(s).
MIDI output with detected notes (note-on and optionally pitch bend messages).
Detected MIDI note number (0-127).
Detected pitch frequency in Hz.
Pitch detection clarity in the range [0..1]. Based on the NSDF peak height. Higher values indicate a more reliable pitch estimate.
Minimum MIDI note to detect. Notes below this value are ignored.
Maximum MIDI note to detect. Notes above this value are ignored.
MIDI output channel (1-16).
When ON, sends pitch bend messages for micro-tuning between semitones. Useful for expressive instruments where pitch doesn't land exactly on a semitone.
Button. Opens the manual page of the selected object (or of its parent module for a control) in the web browser. If no page exists for this object, an error is traced in the trace panel.
For more details about information/help creation, see create-help-file.
Free multi-line text attached to the module, saved with the patch. It is only meant as an internal note for the patch designer: it is not displayed in the interface.
visible only in god mode, see setup-panel-tab-expert.
Read-only, not saved. Current private numeric ID of the object, used internally to identify it (for example as the target of a bind ID).
Read-only, not saved. Private ID used to store and recall the values of this control in presets.
Button. Generates a new unique ID, original ID and preset ID for the object. Use it if you experience difficulties in Polyphonic mode or if two objects share the same ID. Preset values and binds referring to the old IDs are lost.
Read-only, not saved. Absolute address of the object in the Usine objects tree, built from the workspace root. This is the address to use to reach the object from scripts, the objects panel or remote messages. Only shown for objects that are registered in the objects list. See objects-address.
Read-only, not saved. Address of the object relative to the current patch, valid inside that patch only. See objects-address.
Free user-defined address for the object (empty by default). When set, the object is also registered in the objects tree under this name, so it can be reached independently of its position in the workspace (the value is also reported in the mouse-over and mouse-down chunks). Changing it rebuilds the objects list. Only available on objects that support a user address. See objects-address.
version 7.0.250121
Edit All Pages