Space reverberation processor based on an impulse generator and a convolution engine.
Audio input flow(s).
Audio output flow(s).
Enables or disables the reverb calculation.
Amount of the original signal and processed signal.
Frequency of the low-cut filter applied to the input before the calculation.
for 20hz frequency, no low-cut filter is applied.
Pre-delay applied to the input before the calculation of the reverb.
Frequency of the 6dB/oct high-cut filter applied to the generated impulse.
Form of the decay slope. Linear slope for low values (plate reverb), exponential slope for high values.
Density of the impulse. Low values increases the amount of early reflections.
Duration in ms of the generated impulse.
Air absorption coefficient. Determines how much late reflections high frequencies are absorbed. Low values gives "clear" late reflections and high values "darker" late reflections.
Duration (in % of the total duration) of early reflections. For 0 only late reflections are generated.
Button. Opens the manual page of the selected object (or of its parent module for a control) in the web browser. If no page exists for this object, an error is traced in the trace panel.
For more details about information/help creation, see create-help-file.
Free multi-line text attached to the module, saved with the patch. It is only meant as an internal note for the patch designer: it is not displayed in the interface.
visible only in god mode, see setup-panel-tab-expert.
Read-only, not saved. Current private numeric ID of the object, used internally to identify it (for example as the target of a bind ID).
Read-only, not saved. Private ID used to store and recall the values of this control in presets.
Button. Generates a new unique ID, original ID and preset ID for the object. Use it if you experience difficulties in Polyphonic mode or if two objects share the same ID. Preset values and binds referring to the old IDs are lost.
Read-only, not saved. Absolute address of the object in the Usine objects tree, built from the workspace root. This is the address to use to reach the object from scripts, the objects panel or remote messages. Only shown for objects that are registered in the objects list. See objects-address.
Read-only, not saved. Address of the object relative to the current patch, valid inside that patch only. See objects-address.
Free user-defined address for the object (empty by default). When set, the object is also registered in the objects tree under this name, so it can be reached independently of its position in the workspace (the value is also reported in the mouse-over and mouse-down chunks). Changing it rebuilds the objects list. Only available on objects that support a user address. See objects-address.
version 7.0.250121
Edit All Pages