Motorised control surface

[cmodica]

I use a BCR 2000. I active it in the Midi IN and Midi OUT setup.

I made a midi learn on a knob. Turn ON the Motorized in the Midi Knob setup.
When i turn the knob on the BCR 2000 the knob in Usine turn. But when i turn the knob in Usine, nothing turn on the BCR

It is like there is no midi out from Usine to BCR !!!

I add the BCR as an OUT DEVICE. But nothing change.

[nay-seven]

Remember we also have a manual...
Here what you can find on the midi learn page

First right click on the Midi device out and activate the motorized option in its settings panel:

Now, for each midi object where you have add a Midi learn for this devices do the same : right clicks to open its settings panel and activate its motorized option:

[cmodica]

Sorry i read the pdf manuel and don't find this paragraph.:rolleyes:

Thank you very much.

[nay-seven]

yes,cause the pdf is only an introduction manual, i was talking about the online manual:

[cmodica]

Yes I will think about this online manuel now.