BrainModular

hello,

I didn't manage to have more than 1 input for a patch. And i was wondering how i can make it ??? I have three tracks,2 are loops players and the third one is a recording sampler.How can i manage to receive the two sampler sounds on the recording sampler??

thank you....

You can achieve that in different ways. (I'm assuming that the loop players are in track 1 & 2, while the recording sampler is in track 3.)

The simplest one (no patching!) I guess would be to use one of the aux busses. Set track 3 input to aux1 or aux2 and use the sends from track 1 & 2. If you don't want 1 & 2 sent to the output, you have two options. Mute the tracks while keeping the send in the default post-fade mode (it won't mute the sends and you can still use the fader to control level), or turn the send to pre-fader and turn down the fader.

With a little bit of patching in track 3 you get a more flexible result: If use have track 1 selected as input to track 3, add an Additional Audio Input module and set the input on that one to track 2.

If you wan't to get more creative with sending all kinds of data here, there and everywhere in Usine, you should check out the Send To/Get From busses!